Cone crusher for metallurgical, construction, road building, chemical industry and silicates crushed materials, and can be disrupted above average ores and rocks of medium hardness. Cone crusher crushing ratio, high efficiency, Low consumption, uniform product size, suitable for medium crushing and crushing various ores, rocks.

With the development of technology, the types of cone crushers are gradually increasing, and the operation and maintenance points must be focused on learning. A comprehensive inspection must be carried out before driving. The main contents are as follows:

(1) Newly installed crusher without test, use manual or crane to move the crusher 2~3r before starting to avoid collision accident.

(2) a cone crusher load start is not allowed, so the crushing chamber to check whether or iron ore blocks or other objects.

(3) Check the width of the discharge opening. If it is not suitable, it should be adjusted in advance.

(4) Check whether various electrical interlocks and audio signals are normal.

(5) Check the oil level and oil temperature in the fuel tank. If the oil temperature is lower than 20 °C, it should not be driven. It must be heated by a heater.

After checking without problems, you can drive according to the driving sequence specified in the operating procedures. Wait until the oil temperature, oil pressure and cooling water pressure reach the specified value. After the oil pump runs for 3~5min, start the crusher and crush.

Running check:

(1) The crushing must be uniform, the strength should meet the requirements. Generally less than 80% of the size of the crushing port.

(2) It is strictly forbidden to enter the crushing chamber and prevent damage to the parts of the equipment.

(3) Always check the oil quantity and oil temperature of the lubrication system. The return oil temperature should not exceed 60 °C.

(4) Check the water-tight drainage of the water seal, and the water is not allowed to run.

(5) Check whether the pipeline of the water cooling system is unobstructed, as well as the amount of water and water temperature.

(6) Pay attention to check the oil pressure of the locking cylinder. The adjusting ring must be operated under the locked state.

(7) Regularly check the wear of the lining and the fastening of each component. If it is found to be loose, detached or severely worn, it should be tightened immediately or replaced on time.

(8) Always check the granularity of the product, and adjust it if it exceeds the regulations.

When parking, stop in the parking sequence as specified in the operating procedures. When the temperature is lower than 0 °C, the water in the water seal and the cooling water pipe should be drained after parking to prevent freezing of the water pipe.

Touchless Car Wash

Leisuwash specializing in manufacture Automatic Car Wash Machine, touchless car wash , Automatic Touchless Car Wash, touchless car wash equipment, robot car wash, smart car wash system, leisuwash 360, leisuwash leibao 360, laserwash 360, leisuwash touchless car wash machine, leisu wash touchless car wash automatic, leisu wash 360 high pressure touchless car wash equipment, robo car wash, touch free car wash, leisuwash 360 touch free car wash, leisuwash 360 price, automatic car wash price, leisuwash in malaysia, no touch automatic car wash machine.
Leisuwash 360 touchless car wash machine high intelligent high quality, with car wash + car care + drying process totally, each car wash takes time 1 minute to 5 minutes which depends on the car wash mode.
Automatic Touch Free Car Wash Equipment more and more popular in car wash business market, as can save employee fees and wash time mostly, bring investor much more benefit profit return. That's why choose the automatic car washing system.

Touchless Car Wash,Automatic Car Wash,Car Wash Machine,Touchless Car Wash Machine

Hangzhou Leisu Cleaning Equipment Co.,Ltd , https://www.leisuwashtouchless.com