Study on Photosynthesis Conditions of Orchard Fruit Trees by Accumulation Light Calculation Software

<

Research on the photosynthesis of fruit trees has been deepened both at home and abroad. In particular, there are many reports on photosynthesis of deciduous fruit trees. For sweet oranges, the photosynthetic characteristics of the tree in particular under natural conditions have not been systematically studied. In the past, the column was studied on the basis of angle plugs and used to test the fruit in the full fruit period. The purpose is to explore the properties of photosynthetic production under natural conditions. Find out the measures to make full use of the potential of photosynthesis to provide theoretical references, and lay the foundation for further research on the mechanism of citrus photosynthesis. Photosynthesis of plants needs to look at the relevant parameters of the accumulated light, and the accumulated light calculation software can effectively calculate the accumulated light and provide more help for the research work.

There have been many studies on the daily changes in photosynthesis, which have been classified into four types: regular curve type, flat type, variable power type, and noon reduction type. This study shows that Jinyang is a reduced type at noon, but the sunny days have a lower a-degree and longer duration than the nocturnal photosynthetic performance. Obviously it is due to strong sunshine and radiation (visible from the amount of accumulated light) at noon on sunny days, which results in overheating of the leaves, imbalance of water metabolism, stomatal closure, increased CO2 input resistance, and decreased efficiency of peroxidation, resulting in photosynthetic disturbance of the leaves. In addition, studies have found that there is also a midday decrease in C concentration. In summary, in the natural state, the high temperature associated with strong sunlight and the photosynthetic physiological barrier caused by the water deficit of p-b-tablet are combined with the higher degree of internal regulation, which is a further increase in the midday photosynthesis depression. the reason.

Computational calculations by the cumulation calculation software and related research comparisons have shown that the changes in the internal and external photosynthetic performance of the canopy are closely related to climatic conditions. Citrus is a kind of low-light-resistance plants with strong resistance to negative. Both light and high temperature can cause photosynthetic disturbance in leaves, which makes the sunny day outside the crown, the extra-canopy photosynthetic efficiency is lower than that inside the crown, and the cloudy outside is higher than the inside of the crown. This is because the leaves and leaves relatively reduce the radiation caused by strong light to the inner leaves of the crown.

WeChat sweep to get more professional information:

Food Waste Pyrolysis Plant

 

Food waste is one of the most important garbage, including the production of food processing waste, family and school canteens and catering industries (kitchen) and edible residual (hogwash). Its main components are complex, is a mixture of oil, water, fruit peel, vegetables, rice, fish, meat, bones and waste plastics, tissues and etc.

China has a huge quantity of food waste, and increasing rapidly.

According to different application range and the actual situation, Shangqiu jinpeng industrial CO., Ltd manufacture Continuous Pyrolysis Plant to solve food waste issues. By this method, we can put off the kitchen garbage treatment thoroughly, make it into fuel oil, carbon black, sync gas(could use as fuel for Continuous Pyrolysis plant).

food waste 

Flow-chat of continuous pyrolysis plant

Food Waste Treatment Equipment

Advantage of continuous pyrolysis plant

1. Large daily capacity of 30 MT raw materials, and can work 24 hours without any stop for 20 days;

2. Auto-loading, auto-discharging and oil coming out at the same time;

3. Only need fuel for the beginning 3-4 hours, then the sync gas generates itself is enough to support heating, saving fuel cost;

4. Low requirement on the raw materials, no need tiny granule, 10cm pieces acceptable for smooth running;

5. High efficiency condensers, more oil output, good quality oil, easy to clean.

6. Sync gas recycling system, fully burned after recycling and utilization, preventing pollution and saving fuel cost.

7. National patent smoke scrubber, can efficient remove the acid gas and dust of the smoke, environmental friendly to meet related national standards.

8. Easy to operate, need less manpower.

 

Technical Parameter of continuous pyrolysis plant

NO.

ITEM

Technical Parameter

1

Suitable Raw Materials

Oil Sludge

2

Operating Mode

Fully Continuous Operation

3

Structure

Horizontal Type Revolve

4

Loading and discharging

Fully automatic feeding and discharging under high temperature at same time

5

Capacity(24h)

20-30Mt

6

Work Pressure

Slightly Negative Pressure

7

Reactor Rotational Speed

1R/M

8

Installation Power

110kw

9

Cooling Method

Cycle water

10

Type of Drive

Sprocket Wheel

11

Heating Method

Hot Air

12

Noise dB(A)

≤85

13

Main Reactor Weight (MT)

About 20Mt

14

Total Weight(MT)

About 45Mt

15

Installation Space Required

60m*20m

16

Manpower

2/shift

17

Shipment

5*40HC

18

Delivery time

≤70Days

 

 

 


Food Waste Pyrolysis Plant

 

Food waste is one of the most important garbage, including the production of food processing waste, family and school canteens and catering industries (kitchen) and edible residual (hogwash). Its main components are complex, is a mixture of oil, water, fruit peel, vegetables, rice, fish, meat, bones and waste plastics, tissues and etc.

China has a huge quantity of food waste, and increasing rapidly.

According to different application range and the actual situation, Shangqiu jinpeng industrial CO., Ltd manufacture continuous pyrolysis plant to solve food waste issues. By this method, we can put off the kitchen garbage treatment thoroughly, make it into fuel oil, carbon black, sync gas(could use as fuel for continuous pyrolysis plant).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Flow-chat of continuous pyrolysis plant

 

 

 

Advantage of continuous pyrolysis plant

1. Large daily capacity of 30 MT raw materials, and can work 24 hours without any stop for 20 days;

2. Auto-loading, auto-discharging and oil coming out at the same time;

3. Only need fuel for the beginning 3-4 hours, then the sync gas generates itself is enough to support heating, saving fuel cost;

4. Low requirement on the raw materials, no need tiny granule, 10cm pieces acceptable for smooth running;

5. High efficiency condensers, more oil output, good quality oil, easy to clean.

6. Sync gas recycling system, fully burned after recycling and utilization, preventing pollution and saving fuel cost.

7. National patent smoke scrubber, can efficient remove the acid gas and dust of the smoke, environmental friendly to meet related national standards.

8. Easy to operate, need less manpower.

 

Technical Parameter of continuous pyrolysis plant

NO.

ITEM

Technical Parameter

1

Suitable Raw Materials

Oil Sludge

2

Operating Mode

Fully Continuous Operation

3

Structure

Horizontal Type Revolve

4

Loading and discharging

Fully automatic feeding and discharging under high temperature at same time

5

Capacity(24h)

20-30Mt

6

Work Pressure

Slightly Negative Pressure

7

Reactor Rotational Speed

1R/M

8

Installation Power

110kw

9

Cooling Method

Cycle water

10

Type of Drive

Sprocket Wheel

11

Heating Method

Hot Air

12

Noise dB(A)

≤85

13

Main Reactor Weight (MT)

About 20Mt

14

Total Weight(MT)

About 45Mt

15

Installation Space Required

60m*20m

16

Manpower

2/shift

17

Shipment

5*40HC

18

Delivery time

≤70Days

 

 

 


Food Waste Treatment Equipment

Food Waste Treatment Equipment,Kitchen Waste Processing,Food Waste Treatment

Shangqiu Jinpeng Industrial Co., Ltd. , http://www.recyclingthewaste.com