Seed hair dryer instructions

Seed blower is also called Seed Air Separator. It is a special instrument for the detection of seed's clarity. The seed blower uses the aerodynamic behavior (floating speed) of the material particles in the airflow to distinguish the various seeds, and finally the seeds are divided into plant seeds, other seeds and impurities. Seed clarity is one of the parameters of seed quality. The influence of this parameter on the crop is very obvious under the condition of seeding. If the seed is of low clarity, it will cause seedling deficiency and seedling breakage. The formula for calculating the seed clarity is: Seed clarity = (total seed weight - impurity weight/total seed weight) × 100%. The seed hair dryer produced by Top Instrument is adjustable in size and is suitable for the removal of many plant seeds. The seed hair dryer can achieve the ideal degree of clarity for grasses such as bluegrass and tall fescue, as well as vegetables, flowers, herbs, and tobacco seeds. Both grain and grain can be widely used, and are widely used in seed scientific research institutions, seed management stations, and seed companies.

Seed hair dryer using method: 1. After the instrument unpacking, please follow the schematic diagram of the assembly; 2. Turn on the power; 3. The seeds or grains to be experimented into the cup, pushed into the cup inside the clamp, press the button Switch, indicating light, rotate the wind adjustment knob to the right (the wind is gradually increased to the right; otherwise, the wind is decreased accordingly). Select the appropriate wind force for the experiment (Also you can adjust the wind at the top of the vertical wind picking duct to adjust the size of the wind ). The size of the wind is adjusted until the item to be inspected is fully uplifted by the upward airflow, and it is advisable that the impurities be trapped in the upper two layers and enter the debris cup. The maximum time is 10 minutes. It can be arbitrarily set in 0-10 minutes. The timer is set to “0” and the machine will automatically stop after 15 seconds. The running time of the timer is 2 minutes for each rotation. Spin to the fifth box, the machine is running for 10 minutes. After the timer is over, if it needs to be started again, the power switch must be turned off and then turned on again; 4. After the experiment is over, the power should be cut off in time to keep the instrument clean.

Seed blower Notes: 1. The wind adjustment knob should be rotated slowly, select the appropriate wind for testing. 2. Each test should be cleaned up. 3. The wind-selection duct is made of plexiglass material. Do not wipe it with corrosive solutions such as alcohol and acetone (if you need to clean it, wipe it with a soft cloth). 4. Do not open the chassis at all times to prevent it. 5. Care should be taken to avoid damage when handling. 6. The user's power outlet must be grounded reliably. Try to use the wall outlet (use caution with the connection board) to prevent it.

Seed blower technical parameters: maximum air volume: 2.31 cubic meters / hour; maximum wind pressure: 785pa; motor power: 160W; timing: 5-10 minutes; dimensions: 60 × 40 × 35CM; working voltage: 220V 50HZ. Seed blower packing list: host, brush, M4 countersunk head screws, fuses, warranty card, Plexiglas tube, Phillips screwdriver, M4 round head screws, instructions, certificate.